Fanimation Kwad 44 FP7644 Series User Manual (English)

Questions and Answers:

E
eric91Jul 29, 2025
Why is my Fanimation Kwad 44 FP7644 Fan so noisy?
- J
  Jeanne WilsonJul 29, 2025
  A noisy Fanimation fan could be due to several reasons. Ensure the blades are properly attached. Check for loose screws in the motor housing and tighten them, but don't overtighten. Also, wire connectors inside the housing might be rattling, so make sure they are not hitting each other or the housing wall. If you are using a solid-state variable speed control, this could be causing motor noise; consider using an alternative control method.
V
Vicki BergAug 8, 2025
What to do if my Fanimation Fan will not start?
- M
  Mrs. Lynn MartinAug 8, 2025
  If your Fanimation Fan won't start, begin by checking the main and branch circuit fuses or circuit breakers. Inspect the line wire connections to the fan and switch wire connections in the switch housings, ensuring the main power is off. Replace the remote control battery with a new one. Also, verify that the reverse switch is fully to one side.
V
Victor SmithAug 17, 2025
How to fix a Fanimation Fan that wobbles excessively?
- W
  Wesley HallAug 17, 2025
  Excessive wobbling in your Fanimation Fan can often be corrected by tightening the setscrews and nuts securely in the downrod support. Also, check the setscrew in the downrod/hanger ball assembly and tighten it. Ensure the groove hanger ball is correctly lined up with the tab, re-hanging it if necessary. Finally, make sure the hanger bracket and/or ceiling outlet box is securely fastened.