Fanimation The Odyn FPD8148 - Assemble Light Kit or Cap; Mount Light Plate; Connect LED Assembly; Install Steel Cap

12
How to Assemble Your Light Kit Assembly or Cap
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws. Assemble
the light plate assembly to the support bracket using
the two key slots in the socket plate. Replace the third
screw and securely tighten all three screws. (Figure 1)
LED Assembly
Glass
Steel Cap Assembly
2 (Option A--for use with light kit)
Connect the 2 single-pin connectors from the LED
assembly to the 2 single-pin connectors from motor
assembly. (Figure 2A)
2 (Option B--for use with steel cap)
If you want to install the steel cap and not the light kit.
Assemble the steel cap to the light plate assembly by
twisting in a clockwise direction. (Figure 2B)
Light Plate
Assembly
Light Plate
Assembly
Light Plate
Assembly
SCREWS (3)
Figure 1
Figure 4
Figure 2A Figure 2B
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
NOTE:
If you have installed your fan with the steel cap,
skip steps 3 and 4.
LED Assembly
Light Plate
Assembly
Figure 3
3. Remove three screws in the light plate assembly.
Assemble the LED assembly to the light plate assembly
using the two key slots. Replace the third screw and
securely tighten all three screws. (Figure 3)
4. Secure the glass to light plate assembly by twisting
in a clockwise direction. Do not over-tighten. (Figure 4)
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
CAUTION