8
Figure 2
Figure 1
Figure 3
Final Fan Assembly
1. Securely attach receptacle from motor to plugs on
Downlight Socket Plate Assembly (Figure 1)
3. Install two Candelabra Bulbs (included - 60 watts max)
in each of the sockets on the Downlight Socket Plate
Assembly. (Figure 3)
CAUTION
To avoid possible electrical shock, be sure electricity is
turned off before installing downlight assembly.
2. Securely attach Downlight Socket Plate Assembly to the
Adapter Plate by tightening three screws provided with the
fan. (Figure 2)
Installing the Canopy Housing
NOTE:
1. Remove the two shoulder screws in the Hanger Bracket
This step is applicable after the necessary wiring
is completed.
with a screwdriver (Figure 1a).
2. Securely attach the Canopy Housing with the shoulder
screws provided and then tighten the screws (Figure 1a).
▲
WARNING
To avoid possible fire or shock, make sure that the
spliced electrical wires are turned upward and completely
pushed carefully up into the junction box and not pinched
between the housing and the ceiling.
3. Securely attach the Canopy Screw Cover over the
shoulder screws in the Hanger Bracket utilizing the keyslot
twist-lock feature (Figure 1b).
Figure 1a Figure 1b
To Next Page
Loading...
