GB-17GB-16
HOW TO USE THE APPLIANCE
e following symbols will appear on the control
panel, next to each control handle :
(
) Black circle: gas o
(
) Large ame: maximum setting
(
) Small ame: minimum setting
• e minimum setting is at the end
of the anti-clockwise rotation of the control
handle.
• All operation positions must be selected
between the maximum and minimum
position.
• e symbol on the control panel,next to the
control handle will indicate which burner it
operates.
Automatic ignition with ame failure safety
device
e appliance is tted with a ame failure safety
device on each burner, which is designed to stop
the ow of gas to the burner head in the event of
the ame going out.
Automatic ignition with ame failure safety
device
e appliance is tted with a ame failure safety
device on each burner, which is designed to stop
the ow of gas to the burner head in the event of
the ame going out.
To ignite a burner:
• Press in the control knob of the burner that
you wish to light and turn it anti-clockwise to
the maximum position.
• If you keep the control knob depressed, the
automatic ignition for the burner will operate.
• You should hold down the control knob for 15
seconds after the ame on the burner has lit. If
after 15s the burner has not lit, stop operating
the device and open the compartment door
and/or wait at least 1 min before attempting a
further ignition of the burner.
• After this 15-second interval, to regulate the
ame you should continue turning the control
knob anti-clockwise until the ame is at a
suitable level. e operating position MUST
be at a position between the maximum and
minimum position.
To Next Page
Loading...
