GB-27GB-26
• Replace parts in the correct order after
cleaning.
– Do not mix up the top and bottom.
– e locating pins must t exactly
into the notches.
USING INSTRUCTIONS
Warnings
• Do not modify this appliance.
• is appliance must be installed by an
authorised technician or installer.
• Prior to installation, ensure that the local
distribution conditions (nature ofthe gas
and gas pressure) and the adjustment ofthe
appliance are compatible.
• e adjustment conditions for this appliance
are stated on the label (or data plate).
• is appliance is not connected to a
combustion products evacuation device.
It should be installed and connected
in accordance with current installation
regulations. Particular attention should be
given to the relevant requirements regarding
ventilaton.
• Before installing, turn othe gas and
electricity supply to the appliance.
• All appliances containing any electrical
components must be earthed.
• Ensure that the gas pipe and electrical cable
are installed in such a way that they do not
touch any parts of the appliance which may
become hot.
• Gas pipe or connector shouldn’t be bent or
blocked by any other appliances.
• Check the dimensions of the appliance as well
as the dimensions of the gap to be cut in the
kitchen unit.
• e panels located above the work surface,
directly next to the appliance, must be made
of non-ammable material. Both the stratied
surfacing and the glue used to secure it should
be heat resistant, to prevent deterioration.
• Turn on appliance tap and light each burners.
• Check for a clear blue ame without yellow
tipping.
• If burners shows any abnormalities check the
following :
– Burner lid on correctly
– Flame spreader positioned correctly
– Burnervertically aligned with injector nipple
To Next Page
Loading...
