GB-25GB-24
Top plate
• Regularly wipe over the top plate using a soft
cloth well wrung-out in warm water to which
a little washing up liquid has been added.
• Dry the top plate thoroughly after cleaning.
• oroughly remove saltyfoods or liquids from
the hob as soon as possible to avoid the risk of
corrosion.
• Stainless steel parts ofthe appliance may
become discoloured over time. is is normal
because of the high temperatures. Each time
the appliance is used these parts should be
cleaned with a product that is suitable for
stainless steel.
Burners
• Remove the burner lids and Flame Spreaders
by pulling them upwards and away from the
top plate.
• Soak them in hot water and a little detergent
or washing up liqui.
• After cleaning and washing them, wipe and
dry them carefully. Make sure that the ame
holes are clean and completely dry.
• Wipe the xed parts of the burner cup with a
damp cloth and dry afterwards.
• Gently wipe the ignition device and ame
supervision device with a well wrung-out cloth
and wipe dry with a clean cloth.
• Before placing the burners back on the top
plate, make sure that the injector is not
blocked.
• Re-assemble the Auxiliary, Semi-Rapid,
Rapid and Triple-Crown burners as follows :
1. Place the ame spreader (4) on to the burner
cup (5) so that the ignition device and the
ame supervision device extend through their
respective holes in the ame spreader.e
ame spreader must click into place correctly.
2. Position the burner lid (1,2,3) onto the ame
speader (4) so that the retaining pins t into
their respective recesses.
To Next Page
Loading...
