GB-39GB-38
• Do not dismantle the tap shafe: in the
event of a malfunction, change the
whole tap.
• Before placing the burners back on the
top place, make sure that the injector
is not blocked.
• A full operational test and a test for
possible leakages must be carried out
after gas conversion, (such as soap
water or gas detector)
• After completing conversion, a
qualied technician or installer has to
mark “V” on the right gas category to
match with the setting in rating plate.
Remove the previous setting “V”
mark.
TROUBLE SHOOTING
• Repairs should be performed by a licensed
technician only.Improper repair may result in
considerable dangerto you and others.
• However, some minor problems can be
resolved as follows :
Problem Probable cause Solution
No ignition No spark Check the
electrical
supply
e cover of
the burner is
not assembled
correctly
Assemble the
cover properly
e gas supply
is disabled
Completely
open the gas
supply
To Next Page
Loading...
