FAR TGV60N - Installation Steps

ENGLISHENGLISH
GB-31GB-30
- An oven must have forced ventilation to install
a hob above it.
- Check the dimensions of the oven in the
installation manual.
- e cut out size must obey the indication.
INSTALLING THE APPLIANCE
1. Remove the pan
supports, the burner
lid and ame spreader
and carefully turn
the appliance upside
down and place it on
a cushioned mat. Take
care that the Ignition
devices and ame
supervision devices are
not damaged in this
operation.
2. Apply the sponge
provided around the
edge of the appliance.
3. Do not leave a gap
in the sealing agent or
overlap the thickness.
Bottom view
Sponge
e thickness of the
sponge is 3 mm. e
width of the sponge is
10 mm.
Do not use a
silicon sealant to seal
the appliance against
the aperture.
is will make it
dicult to remove the
appliance from the
aperture in future,
particularly if it needs
to be serviced.