68
SECTION 10 -- ENGINE -- CHAPTER 1
10. Before inserting the control rods, check that the
spherical seat (1) of contact with the rocker arm
adjuster screw and the spherical end (2) of con-
tact with the tappet show no sign of wear; if there
are, then change them. The inlet and exhaust
valve control rods are identical and can therefore
be interchanged.
MIF1011A
128
-- Spread LOCTITE 5999 sealant between the cov-
er (2) and the manifold (3) and tighten the screws
(1) to the torque prescribed on page 12.
MIF1094A
129
Fitting the Injectors
(Disassembly operation 50.)
1. On the injector (1), mount a new seal (2) lubri-
cated with Vaseline and a new washer (3).
2. Fit the injectors 2, 3, 4 in the seats on the cylinder
head and tighten them to the torque prescribed
on page 12.
MIF1063A
130
To Next Page