7. Install the bulb holder by pushing it in and
turning it clockwise.
8. Install the bulb holder cover and the
cover at the rear of the headlight.
1CAUTION:
Make sure the headlight bulb holder cover is
securely fitted over the bulb holder and
seated properly.
9. Close the hood.
10. Adjust the headlight beam if necessary.
Tail/Brake Light Bulb Replacement
If a tail/brake light bulb burns out, replace it
as follows:
1. Take down the tail light from carrier.
1. Rear tail light
2. Remove the bulb holder (together with
the bulb) by turning it counter clockwise.
3. Push the defective bulb in and turn it
counter clockwise to remove it from the
bulb holder.
4. Push a new bulb in and turn it clockwise
to install in the bulb holder.
5. Install the bulb holder (together with the
bulb) by turning it clockwise.
To Next Page
Loading...