EasyManua.ls Logo

Farr 400UTV - Crossing through Shallow Water

Farr 400UTV
156 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7-11
Before starting down hill, make sure the
vehicle is in low-range 4WD. On most
slopes, this will let you use engine braking to
help you go downhill slowly. Go as slowly
as possible. If you start going too fast,
gently apply the brakes. Avoid sudden
application of the brakes, which could cause
the vehicle to start sliding.
If you are sliding or skidding, try to steer in
the direction the vehicle is sliding to help you
regain control.
If you must turn on the hill to avoid an
obstacle, do so slowly and carefully. If the
vehicle starts to tip, gradually steer in the
downhill direction if there are no obstacles in
your path. As you regain proper balance,
gradually steer again in the direction you
want to go.
CROSSING THROUGH SHALLOW WATER
If you must cross shallow, slow moving water
up to the depth of the vehicles floorboards,
choose your path carefully to avoid sharp
drop-offs, large rocks, or slippery surfaces
that could cause the vehicle to overturn.
Never operate through water deeper than 33
cm (13in) or fast flowing water.
Wet brakes may have reduced effectiveness.
After leaving the water, test your brakes. If
necessary, apply the brakes several times to
let friction dry out the linings.

Table of Contents