1. Jumper cable positive lead
2. Jumper cable negative lead
5. Connect the negative lead of the jumper
cable to the negative terminal of the
charged battery and the other end of the
negative lead to an unpainted metal
surface of the vehicle.
NOTE:
Do not connect the negative lead of the
jumper cable to the negative terminal of the
battery in the vehicle.
Be especially careful not to:
● touch the positive lead of the jumper
cable to the negative lead.
● reverse the polarity of the jumper cables
when connecting to the batteries-battery
explosion and/or serious damage to the
electrical system may occur.
6. Start the engine. (Refer to“Starting a
cold engine”on pages 6-1—6-3.)
7. After the engine starts, disconnect the
negative lead of the jumper cable from
the vehicle and charged battery, and
then disconnect the positive lead of the
jumper cable from the charged battery
and the battery in the vehicle.
8. Install the battery compartment cover.
9. Close the hood.
To Next Page
Loading...