a D:GROUP company
00020EN Rev.09 – 12/2012 5
2.C ELECTRIC/GAS CONNECTIONS
The electrical connection of FLOWFAST H cabinet is made by connecting the power cable located on the upper of
the right side of the cabinet to a 230V, 50 Hz outlet (if not distinct voltages/frequencies are shown on the label stuck
near the power cable)
If stipulated by local legislation, insert upstream of the power cable an automatic protection overload switch provided
with a differential relay, with a rated switching voltage no greater than 30 mA.
The right side of the bench can be equipped with one or more gas/vacuum intakes with manual tap.
The connection with the gas/vacuum intake is made according to the type of connection: town gas or industrial gas
(air, vacuum, nitrogen, etc.).
The cabinet must be connected with the town gas line through an approved conduit, for safety reasons.
To Next Page
Loading...