Faytech FAY-003 - Boot Sequence Configuration

3-9
Chapter 3: BIOS setup
To set a user password:
1. Select the User Password item and press <Enter>.
2. From the Create New Password box, key in a password, then press <Enter>.
3. Conrm the password when prompted.
To change a user password:
1. Select the User Password item and press <Enter>.
2. From the Enter Current Password box, key in the current password, then
press <Enter>.
3. From the Create New Password box, key in a new password, then press
<Enter>.
4. Conrm the password when prompted.
To clear the user password, follow the same steps as in changing a user assword,
but press <Enter> when prompted to create/conrm the password. After you clear
the password, the User Password item on top of the screen shows Not Installed.
3.6 Boot menu
The Boot menu items allow you to change the system boot options.
3.6.1 BootConguration
Quiet Boot [Enabled]
This item enables/disables Quiet Boot. Conguration options: [Disabled] [Enabled]
Network Stack [Enabled]
This item allows user to disable or enable the UEFI network stack. Conguration
options: [Disabled] [Enabled]
3.6.2 Boot Option Priorities
These items specify the boot device priority sequence from the available devices.
The number of device items that appears on the screen depends on the number of
devices installed in the system.
• To select the boot device during system startup, press <F7> during POST.
• To access Windows OS in Safe Mode, press <F8> after POST.