37X INSTALLATION & OPERATION MANUAL
372/373 MODELS
23
WATER AND BRIX CALIBRATION (Figure 7.13) – Provides a step-by-step process for calibrating the flow controls for the
solution modules. Images and instructions are provided in each step.
LINE VOLTAGE CALIBRATION (Figure 7.14) – Calculates the voltage offset. To use this function, first measure the line
voltage on the contactor with a voltmeter, then enter that value into the menu. Once entered, the dispenser will calculate
the voltage offset and correct the readout in the READOUTS menu.
Figure 7.13
Figure 7.14
To Next Page
Loading...
