feedback Twin Rotor Mimo System - Switch Settings - 16 Bit Board

CHAPTER 3
TWIN ROTOR MIMO SYSTEM
PCL – 812 Card Settings Installation and Commissioning
33-007-03-2
3.1 SWITCH SETTINGS - 16 BIT BOARD
Switch SW1 controls the base address for I/O transfer (switches 1-6), and the CPU wait
states (Switches 7-8). They should be set as follows.
( Note that the MIMO software always refers to the decimal settings, whereas the manual
on the PCL-812 board refers to hexadecimal settings. For convenience, both decimal and
hex addresses are shown in the table below ).
SW1 Base Address Selection
I/O Address Range (hex
and decimal)
SW1 Switch position
123456
200-20F (512-527 Dec) OFF ON ON ON ON ON
210-21F (528-543 Dec) OFF ON ON ON ON OFF
220-22F (544-559 Dec)
*
OFF ON ON ON OFF ON
230-23F (560-575 Dec) OFF ON ON ON OFF OFF
300-30F (768-783 Dec) OFF OFF ON ON ON ON
3F0-3FF (1008-1023 Dec) OFF OFF OFF OFF OFF OFF
*
Factory default setting
Note that some video cards or floppy disk drives use the higher base
addresses such as 1008 (Hex 3F0), and should be avoided if possible.
SW1 Wait State Selection
SW1 Switch Settings
Time Delay
78
0
*
ON ON
2OFF ON
4ON OFF
6OFF OFF
*
Factory default setting
☞