Manual VEK MNE1 / VEK MNE2
4 09/2015 FEIG ELECTRONIC GmbH
GBR
1 Safety Precautions and Warning Notes
• The device must only be used for the purpose intended by the manufacturer.
• Store the operating instructions in an accessible location and pass it on to every user.
• Unauthorized modifications and the use of spare parts and accessories, which are not sold or recom-
mended by the manufacturer of the equipment, can result in fires, electric shock and injury. Therefore,
such measures lead to an exclusion of liability and the manufacturer will not accept liabilities.
• For the device, the manufacturer's warranty provisions in force at the time of purchase are valid. No liabil-
ity is assumed for improper or wrong manuals or automatic adjustment of parameters of a unit or the im-
proper use of a device.
• Do not open the enclosure.
• Repairs shall only be carried out by the manufacturer.
• The power source used must meet the requirements for SELV circuits and current limited power sources
in accordance with EN 60950-1.
• Connecting, commissioning, maintenance, testing and adjustment work on the traffic detector must be
carried out by qualified electricians with the relevant accident prevention training.
• Observe valid VDE regulations when handling devices that are exposed to electrical voltage. In particular,
but not limited to, these are VDE 0100, VDE 0550/0551, VDE 0700, VDE 0711, VDE 0860, VDE 0105, as
well as the fire and accident prevention regulations BGV A3 (previously VBG 4).
• The fact that an operational indicator turns off is no indication that the unit was disconnected from the
power supply and that it is de-energized.
• All work on the unit and its installation must be carried out in accordance with the national electrical codes
and local regulations.
• It is the responsibility of users or installers to make sure that the equipment is installed and connected in
accordance with recognized engineering practice in the country of installation and relevant local regula-
tions. Particular attention must be focused on cable dimensions, fuses, grounding, shutdown, isolation,
insulation monitoring and overcurrent protection.
• The combined operation of extra low and low voltage on both outputs of the relays is not permitted!
• The round plug corresponds to the basic insulation properties. If the relay contacts carry voltages > 48
VAC/DC as well as for all -R230 versions, the isolation of all connecting cables of the 11-pin round plug
must be designed for 230 V AC.
• The device must not be used as a safety unit in accordance with the Machinery Directive 2006/42 / EC,
the Construction Products Directive 89/106 / EEC or any other safety regulation. In systems with potential
risks, additional safety equipment is required!
2 Maintenance
The unit does not contain parts that need servicing by the installer or user.
Do not open the enclosure.
To Next Page
Loading...
Need help?
General
