26
!
"
#
$
%
Bandsaw
FB 540/640/740/840/940
Fig. 19: Wheels
Operation
To correct the saw belt movement on the wheels, open
the clamping lever and twist the adjusting screw. The saw
belt moves inwards when turning in a clockwise direc-
tion and if turning in an anti-clockwise direction, the saw
belt moves outwards. A quarter of a turn is sufficient to
change the movement distinctly. Once the setting is cor-
rect, clamp the clamping lever again tightly.
Close the saw belt duct and both doors and position the
air brake switch to the brake position.
!Handwheel
"Clamping lever
#Adjusting screws
$Clamping screw
%Handwheel
Attention: Once the machine is no longer in use, loosen the belt tension and place an appropriate warning
sign on the machine. This will thus prevent damage to the wearing surface of the wheels.
To Next Page
Loading...
