ENGLISH
IMPORTANT SAFETY INSTRUCTIONS — Please Read Before Using!
• The socket-outlet shall be installed near the equipment and
shall be easily accessible.
• To prevent electrical shock, do NOT use laminator close to
water and do NOT spill water on laminator, electric cord, or
wall socket.
• Do not leave electric cord in contact with a warm surface.
• Do not leave electric cord hanging from a cupboard or shelf.
• Do not use laminator if electric cord is damaged.
• Do not laminate metal objects.
• Only use pouches specically designed for the lamination setting you intend to use.
• Always supervise children during laminator operation.
• Keep pets away from laminator while in use.
• Switch off and unplug laminator when not in use.
• Only open the laminator as explained under “Maintenance”. Do not open or attempt
to repair in any other way, as this could result in electric shock and will void your
warranty. Contact Customer Service if you have questions. Please note the warranty
does not apply in cases of abuse, mishandling or unauthorized repair.
• Please be careful of sharp edges and corners and residual heat when opening
the laminator.
2
Discrete carry
handles at side
Active Cooling System
Temperature controlled
release trigger for lid
Support Shelf on entry to
guide Laminate path
LCD Interface for
user guidance
HeatGuard Technology™ double-walled
insulation keeps heat inside
Opening lid to clean
laminating mechanism
CAPABILITIES
Pouch Thickness 75-250 microns
Estimated Heat-Up Time 4 Minutes
Approximate Cool-Down Time 60 Minutes
Lamination Speed 50 cm/Minute
Maximum Width 330 mm
Voltage 220 - 240V~
Frequency 50/60 Hz
Laminating capacity – 75 to 250 micron hot laminating pouches per side
(min: 2 x 75 = 150 micron; max: 2 x 250 micron = 500 micron pouches)
Up to A3 width (330mm)
1000 Watt
Dimensions: 555mm (w) 245mm (d) 120mm (h)
Max document thickness 1mm
IMPORTANT SAFETY INFORMATION
This laminator is equipped with an Auto shut-
off function. It will turn the laminator into
stand-by mode, if it has not been used for
over 60 minutes. The LCD screen will show
the sleep screen when in stand-by.
To switch the laminator back on, simply press the
stand-by button at the left of the front operating
panel.
During lamination, the direction of the pouch can be
reversed, if you are unsure about the progress of the
lamination. To do so, press down the reverse key.
This will eject the pouch back at the front entry.
To Next Page
Loading...
