FENDT 920 Vario - 9. Tractor Management System (TMS)

49
OPERATION
Operation_Pic_number:1
A = Current fuel consumption.
B = Average fuel consumption.
Measurement at tractor START or
Press button (F3). Display is reset to '0'.
C = 1. Unit counter (e.g. for comparing the
same operation when different driving
styles are used).
Measurement at tractor START or
Press key (F4). Display is reset to '0'.
D = 2nd sum counter (e.g. comparisons of
the same work done with different dri-
ving methods).
Measurement at tractor START or
Press key (F5). Display is reset to '0'.
Text-module
NOTE:
Maximum value for the sum counter is
30000 litres, then measuring starts at 0 again.
Fig.79
9. Tractor Management
System (TMS)
Text-module
MODE 1
Joystick - engine management system off
The transmission ratio is set with the joystick, the
engine speed is set with the accelerator.
Text-module
MODE 2
Joystick - engine management system on
Driving speed is set with the joystick; the engine
speed and transmission ratio are set automati-
cally.
NOTE:
If the TMS is active and change of direction is
programmed, the speed is taken up indepen-
dent of the engine speed.
Text-module
MODE 3
Accelerator - engine management system off
The transmission ratio and the engine speed are
set with the accelerator.
Text-module
MODE 4
Accelerator - engine management system on
Driving speed is set with the accelerator; the en-
gine speed and transmission ratio are set auto-
matically.
NOTE:
If TMS is active and there is a programmed
change of travel direction, only the current
speed is obtained.