Need help?Do you have a question about the FENDT 920 Vario and is the answer not in the manual?
General| Rated engine speed | 2100 rpm |
|---|---|
| Hydraulic System | Load-Sensing |
| Max Speed | 50 km/h |
| Engine Type | 6-cylinder turbocharged diesel |
| Transmission | Continuously Variable Transmission (CVT) |
| Tire Options | Various options available |
Details the location and function of the tractor's dashboard displays and controls.
Explains the operation of the Vario transmission system, including joystick and neutral functions.
Explains the TMS modes for optimizing engine and transmission control for various operations.
Covers the operation, engagement, and disengagement of the Power Take-Off (PTO) systems.
Describes how to use automatic modes for controlling the power lift and PTO via the joystick.
Covers the operation and safety checks for the foot brake, hand brake, and trailer brake.
Provides general notes, valve equipment, and operating procedures for the hydraulic system.
Details the controls and operation of the electronic lifting gear system at the rear.
Explains how to set up and operate attached implements using the tractor's control terminal.
Details the Variotronic Ti system, including functions, triggers, menus, and operating sequences.
Explains how warning and fault messages are displayed and how to interpret them.
Lists and describes fault messages specific to the Variotronic Ti system.
Details warning and information messages related to implement setup and operation.
Provides a comprehensive list of fault codes, their causes, and suggested remedial actions.
Outlines the procedure for emergency operation when electronic systems fail.
Important general information and safety precautions before performing maintenance.
Step-by-step guide for draining engine oil and replacing the oil filter.
Covers checking hydraulic oil levels, changing hydraulic oil, and replacing filters.
Information on locating and identifying fuse holders and starter relay fuses.
To Next Page