Ferno XT - 6.2 Head Immobilisation

21
© Ferno s.r.l. MU-086-G Rel.01102019
XT-PRO Extrication Device
6.2 HEAD IMMOBILISATION
Fit the QHI head cushion with the relevant Velcro strap.
Fit the triangular head immobiliser with the relevant straps.
Make sure that all three passages in the buckle are correctly
realised:
1- Insert the straps in the head end hole from inside the
extrication device.
2-Insertthestrapintherstloopofthefasteningbuckle.
3- Then insert it in the second loop and pull to fasten the strap.
Warning!
- Failure to complete the three passages may cause undesired
loosening of the strap.
1
3
2