Ferno XT - Maintenance; 8.1 XT Maintenance; 8.2 XT-PRO Maintenance

42
© Ferno s.r.l. MU-086-C Rel.12062019
XT-Floating Extrication Device
The same handles can also be used to lift the patient out of
water.
Warning!
Thepartoftheoatsbeyondthepelvismustalways
remainfreetooat,withoutanyrestraint.
8  MAINTENANCE
8.1 XT maintenance
INSPECTION BEFORE USE
To ensure optimal use of the device, it is important to
keep all the components in good conditions and to remove
alltracesof dirt, debrisand body uids.The XT must be
inspected before and after each use;theXTmustbecleaned
after use. When not in use, it must be stored in a dry, indoor
environment and inspected at least once a month. If wear or
damage is found during the inspection, the device must be
put out of service.
PREVENTIVE INSPECTION
The XT is a medical device requiring regular maintenance.
The user is responsible for preventive inspection operations
as listed in the detailed checklist attached to this manual and
forllingouttherelevanttable.
ROUTINE INSPECTION
The XT should undergo a complete overhaul and product
certicationcarriedoutbyFernopersonneleverytimethat
the inspection reveals cracks on the board, deep scratches or
wear signs on textile components. After that, the customer is
responsible for contacting Ferno Technical Support Service
for repair/maintenance. See chapter Technical Support.
If the XT undergoes particularly heavy use, if it is used
in an environment contaminated by hazardous chemical
substances or for carrying heavy loads, maintenance should
preferably be carried out on a more frequent basis.
Ferno directly carries out repair maintenance operations,
without the need of dealers, mechanics or external service
centres. You are thus invited to be wary of those who present
themselves as Ferno's authorised technician.
8.2 XT-PRO maintenance
INSPECTION BEFORE USE
To ensure optimal use of the device, it is important to keep
all the components in good conditions and to remove all
traces of dirt, debris and body uids.The XT- PRO must
be inspected before and after each use, and must be cleaned
after use. When not in use, it must be stored in a dry, indoor
environment and inspected at least once a month. If the
inspection reveals cracks on the board, deep scratches or
wear signs on textile components, place the device out of
service and contact Ferno's technical support.