Ferno XT - Page 24

24
© Ferno s.r.l. MU-086-G Rel.01102019
XT-PRO Extrication Device
In case of extrications or transports in complex environments,
the XT can be hanged by means of an anchor device (EN
566:2006), such as a validated textile ring with a minimum
length of 120 cm, and a connector (EN 362).
If needed a shorter hanging system can be used by applying
a ring with the same features and following the procedure
below.
REAR
WARNING
The ring should be simply put around the board, as
the gures show.
WARNING
For the specic maintenance of textile ring and
hook, refer to the manufacturers of the devices.