Ferno XT - Page 45

45
© Ferno s.r.l. MU-086-G Rel.01102019
XT Extrication Device
Preventive Maintenance
intervals
After each use Whenever necessary Every month
Disinfection
• •
Cleaning
•
Inspection
• • •
3. Disinfect all equipment (including accessories such as head
immobiliser, restraints, etc.) with a cloth or sponge dampened
with disinfectant solution, let it sit for 10-20 minutes; use
brushestorubandcleantheleastaccessibleparts;
4. Use a cloth to rinse and dry the treated surfaces, make
sure that all the device's components are completely dry
before using them.
Warning:
Concerning points 3 and 4 in any case check the procedures
recommended by the disinfectant manufacturer.
Do not immerse the device directly in disinfectant.
During disinfection, use gloves and the appropriate PPE
according to the risk assessment guide.
Also ensure there are no signs of wear and/or damage.
CLEANING AND DISINFECTING RESTRAINTS WITH
METAL BUCKLES
The sanitisation of restraints must be carried out at the end
of the shift or after each transport, if necessary.
WARNING: never immerse the restraints completely in
water and never wash them in the washing machine.
* When there is no contamination from organic substances,
it is possible to just disinfect the restraint by just spraying
disinfectant and leave it to dry.
* In case of surfaces visibly contaminated by organic
substances (blood, urine, vomit, faeces, etc.) proceed with
decontamination according to the following procedure:
1. Wear suitable PPE based on the Risk Assessment
Document.
2. Remove the material using a disposable cloth and/
or paper and dispose of it inthe specic container for
special waste.
3. Sanitise.
4. Before starting sanitisation, move all restraint hooks
upwards.
5. Sanitisation is carried out by immersing the restraints
in a container and leaving them to soak in water with
sanitising product, and leaving the metal parts outside
the container.
Leave to soak for approx. 10-20 minutes then dry with
paper.
6. Afterwards hook up all hooks together and hang the
restraints to a support.
7. Clean by directly spraying the cleaning and disinfecting
product then leave it to dry.
8.Re-ttherestraintsonlyoncetheyaredry.
CLEANING RESTRAINTS WITH PLASTIC BUCKLES
1. Remove the restraints from the product.
2. Place the restraints inside a mesh bag (not supplied with
the products) and put it in the washing machine.
3. Wash the restraints with hot water using a cleaning and
disinfecting product and selecting a cycle for delicate items,
with slow spin. Do not bleach.
4. Remove the restraints from the mesh bag and let them dry
in the open air. Do not tumble dry.
5.Re-ttherestraintsonlyoncetheyaredry.
CLEANING FLOATS, LEG HOOPS AND TRIANGULAR
HEAD IMMOBILISER
1.Removetriangularheadimmobiliser,oatsorleghoops
from the board.
2.Opentheoatzipperandextractthestufng.
3. Immerse the triangular head immobiliser, leg hoops,
stufngandcoversinacontainerandleavethemtosoak
inwaterwithsanitisingproduct.Checkthatthestufng
is completely immersed in liquid.
Leave to soak for approx. 10-20 minutes then dab with
paper and leave it dry with paper in a dry and clean place.
4.Oncetheyhavedried,retstufnginsidecoversandt
the board with oats or leg hoops and triangular head
immobiliser.