Messages on the multi-function display
The symbol colour denes the priority:
Green: normal conditions of use
Red: when a fault has been detected
Amber: when the driver is requested to
check the system.
The following symbols will appear to
identify each wheel, the ‘solid’ square
indicating the tyre involved:
• FL front left-hand wheel
• RL rear left-hand wheel
• RR rear right-hand wheel
• FR front right-hand wheel
Pressure indication for each tyre
It can be activated by pressing
MODE button (see page 39)
on the multi-function display to
view the pressure of each tyre.
If requested when the data is not available,
(e.g. during the calibration procedure) the
symbols will be shown with -.- instead of
the value.
Tyre pressure check request without
indication of the wheel
Activated for a few seconds
after the engine has started. It
indicates a drop in pressure with
respect to the last value stored.
The system ignores which tyre is involved
since it has not yet identied the position.
Check the pressure of all the tyres.
Tyre pressure check request
Activated for a few seconds after
the engine has started, but unlike
before, the system indicates
which wheel is signalling the
fault.
Check the pressure of the tyre indicated.
Puncture without wheel indication
Activated when a puncture occurs,
ignoring the tyre involved since
the system is not yet calibrated. It
remains on until the ignition key
is turned to position 0.
Follow the instructions in the section
“Replacing the wheels” on page 82 when
only one tyre has a puncture.
Puncture with wheel indication
Activated when a puncture
occurs, indicating the tyre
involved. It remains on until the
ignition key is turned to position
0.
Follow the instructions in the section
“Wheels and tyres” on page 82 when only
one tyre has a puncture.
System calibration request
Activated for a few seconds
after turning the ignition key
to position II to signal that the
system is not calibrated.
Adjust the tyre pressure and calibrate the
system (see page 125).
Conrming the calibration procedure
With the ignition key in position
II (without starting the engine)
the warning light comes on after
pressing the calibration button
for about 5 seconds.
The warning light goes off when the engine
has started.
During calibration, the tyre condition may
be displayed partially (pressure not shown)
even if the system has already learned the
position from the sensors.
System faulty
The system does not respond or
is defective.
Have the system repaired at an Authorised
Ferrari Service Centre.
System temporarily inactive
Appears when the system is
temporarily unable to function.
This may occur because of
external electromagnetic
interference or excessive sensor
temperature.
The system automatically resets once the
normal conditions are restored.
The message appears in the event of system
components replacement.
To Next Page
Loading...
