The spare wheel is not tted with a tyre
pressure monitoring sensor (see label on
spare wheel bag). Hence, after tting, the
wheel is not monitored by the system,
however, it complies with International
Regulation ECE R64/01. Once tted,
we recommend you go to the nearest
Authorised Ferrari Service Centre.
After removing the spare wheel
support, put the tools and the
replaced wheel back into the luggage
compartment.
Replacing the front direction indicator and
position light bulb
To access the headlight bulbs, steer the
wheels completely to the inside and remove
the inspection lid positioned on the front
part of the wheelhouse.
• Disconnect the battery using the battery
master switch (see page 101).
• Turn the bulb holder A anticlockwise and
remove it from its seat.
Before replacing a bulb, always disconnect
the battery (see page 101) and check that the
corresponding fuse is intact.
When reconnecting the battery, follow the
procedure described on page 101
.
Low beams/high beams
The low/high beams have high-voltage bi-
xenon lamps.
Avoid any operation with the ignition key in
position II.
For replacement, contact the Ferrari Service
Network
.
For headlamp beam aiming, contact the
Ferrari Service Network
.
To Next Page
Loading...
