If you make a mistake, turn the key to
position 0 and repeat the operation from
step 1.
1) Read the 5-digit electronic code found
on the CODE CARD.
2) Turn the ignition key to position II:
at this point, the CODE and EOBD
warning lights stay on.
3) Push and hold down the accelerator
pedal. After approximately 8 seconds,
the EOBD warning light will go off.
Release the accelerator pedal and get
ready to count the number of times the
EOBD warning light ashes.
4) Wait until the number of ashes is
equal to the rst digit of your CODE
CARD, then push and hold down
the accelerator pedal until the EOBD
warning light goes off after about 4
seconds, then release the accelerator
pedal.
5) The EOBD warning light starts ashing
again. When the number of ashes
is equal to the second digit of your
CODE CARD, push and hold down the
accelerator pedal.
6) Proceed in the same manner for the
remaining digits in the code on the
CODE CARD.
7) When the last digit has been entered,
hold the accelerator pedal pushed
down. The EOBD warning light comes
on for 4 seconds and then goes off;
release the accelerator pedal.
8) When the EOBD warning light ashes
fast (for about 4 seconds) it con rms
that the procedure has been carried
out correctly.
9) Proceed with starting the engine by
pressing the ENGINE START button
on the steering wheel.
If the EOBD warning light remains on,
turn the key to position 0 and repeat the
procedure from step 1.
This procedure can be repeated an
unlimited number of times.
After an emergency start, it is advisable to
contact the Ferrari Service Networkas
the emergency starting procedure has to be
carried out for each starting.
Electronic alarm system
The electronic alarm system carries out the
following functions:
- remote control for central door locking;
- perimeter surveillance, detecting when
the doors or lids are opened;
- car movement surveillance.
The engine immobilizer function is
guaranteed by the Ferrari CODE system,
which is automatically activated when the
ignition key is removed from the switch.
System activation
Press button A on the key to activate the
alarm system:
To Next Page
Loading...
