46 ferrismowers.com
Problem: Streaking
Not overlapping enough when
turning.
When turning your effective cutting
width decreases–overlap more when
turning.
Problem: Scalping
Scalping is when the mower deck comes close to or hits the ground.
Scalping can be caused by the mower deck misadjustment, unevenness in
the lawn, or by mower deck bouncing because the ground speed is too fast.
Cause Remedy
Lawn is uneven or bumpy. Roll or level the lawn.
Mower deck cutting height is set too
low.
Raise the cutting height.
Ground speed is too fast. Slow down.
Deck is not leveled correctly. Correctly level the deck.
Tire pressure is low or uneven. Check and inflate the tires.
Problem: Stepped Cutting
Stepped cutting is sharp ridges or uneven levels left in the lawn
surface. Stepped cutting is usually caused by mower deck damage or
misadjustment, or damage to the mower blades.
Cause Remedy
Deck is not leveled correctly. Level the deck correctly.
Tires are not properly inflated. Check and inflate the tires.
Blades are damaged. Replace the blades.
Deck shell is damaged. Repair or replace the deck.
Mower spindle is bent or loose. Repair or replace the spindle.
Blades are installed incorrectly. Reinstall the blades correctly.
Problem: Uneven Cutting
Uneven cutting is waviness or smooth troughs in the lawn surface. Uneven
cutting is usually caused by mower deck damage or misadjustment.
Cause Remedy
Deck is not leveled correctly. Level the deck correctly.
Blades are dull or worn. Sharpen or replace the blades.
Blades are damaged. Replace the blades.
Deck is clogged with grass clippings. Clean out the deck.
Deck shell is damaged. Repair or replace the deck.
Mower spindle is bent or loose. Repair or replace the spindle.
Problem: Uneven Cutting
Blades are installed incorrectly. Reinstall the blades correctly.
Tires are not properly inflated. Check and inflate the tires.
Problem: Stringers
Stringers are sparse patches of uncut grass left behind the mower.
Stringers are usually caused by operator error or poor blade maintenance.
Cause Remedy
Blades are not sharp or nicked. Sharpen your blades.
Blades are worn down too far. Replace your blades.
Engine speed is too slow. Always mow at full throttle.
Ground speed is too fast. Slow down.
Deck is plugged with grass. Clean out the mower.
Specifications
Specifications are correct at time of printing and are subject to
change without notice.
ENGINE
For complete engine specifications see the engine
manufacturer's operator's manual included with your unit.
Fits models: 5901702, 5901703& 5901908
18.5 HP Kawasaki
Make Kawasaki
FS600V-DS00-S (S/N: 2016360971
and below)
Model
FS600V-ES00-S (S/N: 2016360972
and above)
Electrical System 12 volt, 15 amp charging coil;
Battery: 340 cca
Fits models: 5901699, 5901701, 5901703, 5901715,
5901716, 5901906, 5901907 & 5901915
Briggs & Stratton Commercial Turf 44T977
Make Briggs & Stratton
Model 44T977-0005-G1
Electrical System 12 volt, 16 amp. alternator; Battery:
350 CCA
Fits models: 5901776, 5901815 & 5901911
Kawasaki FS691V
Make Kawasaki
Model FS691V-ES00-S
Electrical System 12 volt, 15 amp charging coil;
Battery: 350 CCA
Fits models: 5902109, 5902110 & 5902112
Briggs & Stratton® CXi 44T977
Make Briggs & Stratton®
Model 44T977-0054-G1