65EN
cod. 3540000272 - Rev. 01 - 01/2024
Accessing the electrical terminal block and fuse
After removing the front panel ( ”Opening the front panel” on page 84 ) it is possible to access the
terminal blocks (M) and the fuse (F) following the directions given below (fig. 19 and fig. 20). The
terminals indicated in fig. 19 must be with voltage-free contacts (not 230V). The arrange-
ment of the terminals for the various connections is also given in the wiring diagram in fig. 46.
fig. 19
fig. 20
To Next Page
Loading...
Need help?
General