Festo CMMP Series Brief Overview

Festo P.BE-K-CMMP-AS-C20 1010NH English 17
1 User instructions
Designated use
The CMMP-AS-C20 series of servo positioning controllers
are intelligent AC servo converters for activation of perma-
nent-magnet-excited synchronous servo motors.
The master controller (PLC/IPC) is connected via one of the
following controller interfaces:
– Digital inputs/outputs
– PROFIBUS-DP
– CANopen
– DeviceNet
– SERCOS II
Commissioning and parametrisation are carried out:
– with the FCT software package and the CMMP-AS plug-in
via the RS232 interface.
Note
This brief overview is part of the documentation
package. It serves only as initial information and does
not replace the complete documentation, which is
contained as a PDF file on the supplied CD-ROM. The
latest version can also be downloaded from our
homepage (www.festo.com).
You must observe the information and the safety in-
structions in the complete manual for the motor con-
troller.
Please consult your local Festo Service or write to the
following e-mail address if you have any technical
problems: service_international@festo.com

Festo CMMP Series Specifications

General

Control Mode	Position, Torque
Communication Interfaces	CANopen, EtherCAT, PROFINET, Ethernet/IP
Power Supply	24 V DC
Feedback System	Incremental encoder, Absolute encoder
Number of axes	1
Relative humidity	5% to 95% (non-condensing)
Operating temperature	0 °C ... +50 °C