To Next PageTo Next Page
Need help?Do you have a question about the Festo DSM Series and is the answer not in the manual?
General| Brand | Festo |
|---|---|
| Model | DSM Series |
| Category | Control Unit |
| Language | English |
Requirements for installation and commissioning by qualified personnel.
General safety guidelines for correct and safe product operation.
Adherence to pressure, force, speed, and temperature limits.
Ensuring a supply of correctly prepared compressed air for operation.
Consideration of prevailing environmental conditions during use.
Adherence to national and local safety laws and regulations.
Slowly pressurizing the system to prevent sudden uncontrolled movements.
Avoiding damage to the drive shaft during handling and mounting.
Minimizing lateral forces applied to the square drive.
Ensuring correct alignment and adhering to force/inertia limits.
Table showing allowed longitudinal and lateral forces for DSM models.
Instructions for pushing the load onto the drive shaft.
Ensuring the load does not slide off the drive shaft.
Preventing hand or object access into the swivel path for safety.
Using GRLA/GRLZ valves to adjust swivel speed.
Slowly pressurizing the entire system for safe startup.
Safety checks and adjustments when working on the DSM unit.
Procedure for setting up and adjusting the flow control valves.
Ensuring operating conditions are within permitted limits before testing.
Methods for pressurizing the drive unit for testing purposes.
Identifying potential reasons for the swivel vane hitting the stop hard.
Stopping the test run and correcting identified issues.
Possible causes and remedies for uneven movement of the movable mass.
Causes and remedies for hard knocking in the end position.
Causes and remedies for the drive shaft not remaining in the end position.
