1
User instructions
The SPC-10 is designed for use in conjunction with a pneu-
matic linear drive type DGP(L)-..., a linear potentiometer type
MLO-POT-...-TFL and a proportional directional control valve
type MPYE-5-... for fast movement between two adjustable
fixed stops with electronically regulated cushioning.
More detailed information on the SPC-10, especially on the per-
mitted valve-cylinder-potentiometer combinations can be found
in the user manual for the SPC-10 (type P.BE-SPC10-...).
CAUTION
This quick reference is directed to users who are familiar
with the SPC-10.
You must observe the safety regulations specified in the
manual for the SPC-10, type P.BE-SPC10-...
PLEASE NOTE
Always switch on the operating voltage supply first and then
the compressed air supply.
Before undertaking installation and/or maintenance work,
switch off the following sources of energy either at the same
time or in the sequence indicated.
1. the compressed air supply
2. the operating voltage supply for the SPC-10.
English
SPC-10-...
9902c 11
To Next Page
Loading...
Need help?
General
