Festo SPC11 2018-12b English 3
1 User instructionsEnglish
The Soft Stop type SPC11-... is intended for fitting into a
machine or an automation system. In conjunction with
permitted drives and measuring systems, as well as with a
proportional directional control valve type MPYE-5-..., the
SPC11 permits fast movement into two end positions set
with fixed stops as well as into one or two mid-positions.
Note
This brief summary is intended only for users who are
familiar with the SPC11. Please observe the safety in
structions as well as the information on the permitted
combinations of valves, drives and measuring systems.
These can be found in the System manual for the SPC11
(type P.BE-SPC11-SYS-...) and in the associated “Drive-
specific supplement”.
Caution
Always switch on the operating voltage supply first and
then the compressed air supply.
Before carrying out installation and/or maintenance
work, switch off the following power supplies either
simultaneously or in the following sequence:
1. compressed air supply
2. operating voltage for the SPC11.
To Next Page
Loading...
Need help?
General
