Festool DOMINO User Manual

75 8
9
6
5352
4
NOTE You can naturally use the DF 700 to apply this
method with a domino diameter of 8 mm or greater.
CAUTION Especially with handrails, it is often not possible
to position the joining machine securely on the side of the
workpiece due to the handrail design; the round shape
prevents the DOMINO joining machine from having a secure
support surface.
The trim stop provides additional support in these cases:
mark out the desired position of the spindles on the handrail,
where routing will take place later. From this marking, set
an additional marking 10 mm away (or 15 mm when using the
DF 700) – this is where the joining machine will be placed
later. Then set the routing angle to 90° so that you can route
vertically into the handrail from the top. The routing depth is
20 mm again, as with the spindles, with the 6 x 40 mm router
to be processed.
Set the routing height to 15 mm, so that the domino is centred
on the spindle later. Set the routing depth to 20 mm, so that
the 40 mm domino is later positioned evenly between the
spindle and the handrail. Route the hole in the spindles using
the narrow hole setting.
2016_FES_DOMINO_Book_GB-en.indb 52 03.03.16 12:13

Festool DOMINO Specifications

General

Motor Power	420 W
Dust Extraction Connection Diameter	27 mm
Power Source	Corded Electric
Cutting Depth	15 mm, 20 mm, 25 mm, 28 mm
Cutter Diameter	5 mm, 6 mm, 8 mm, 10 mm