FHF ExResistTel - Configuration - PIN; Configuration - Phone Lock

24
Configuration - PIN
With the entry element PIN, the personal identification number, which
must be entered on request of the PIN to authorise oneself to make
changes to the configuration, must be specified.
Notes:
 The factory setting "0000" causes the switching-off of the PIN-
protection; configuration settings may be changed without request of
the PIN.
 A successful response to the PIN request remains in place until the
menu is terminated. Further changes can be made without a re-
peated request of the PIN.
 If you change the PIN, don´t forget the new PIN. Forgetting the PIN
is the equivalent of losing a key. If you forget the PIN, please contact
your distributor or manufacturers representative.
Factory setting:
PIN....................................... "0000":4 // 0-Pin, change without PIN request!!!
Configuration - Phone Lock
With the option switch Activate, specify whether, and in which man-
ner, the telephone is locked and the choice of telephone numbers is
limited. In addition to the limitation of choice, the access to the main
menu, with the telephone in locked mode, is blocked. Disabling of the
lock is undertaken in the unlock menu, which can be opened by press-
ing the key .  S 19 Operation – when the phone is locked. The fol-
lowing locks are available.
Off Telephone lock is inactive.
Phone Book Telephone is locked, only the numbers in the telephone directory can be
dialled.
Direct Call telephone is locked, only numbers with specified entry element Direct
Call No can be dialled.
Total Telephone is locked, no dialling possible.
Notes:
 Putting the locks Phone Book and Direct Call assumes that the
telephone directory or the direct call numbers are not blanked out.
Factory setting:
Activate ....................................... Off // Telephone lock is inactive.
Direct Call No ......................"":32 // Blank