FIBARO FGCD-001 - 2: Basic Activation

4
BASIC ACTIVATION
#2: Basic activation
1. Turn the cover counter-clockwise.
NOTE
Recommended height
of installation is de-
pendant on the pur-
pose of the room and
height at which head
typically is.
i
NOTE
FIBARO CO Sensor
may operate as a
stand-alone carbon
monoxide detector or
may be used in coop-
eration with Z-Wave
Controller (eg. FIBARO
Home Center) as a part
of smart home system.
i
PULL
1xCR123A(3V)
B
e
e
p
!
PULL
1xCR123A(3V)
PULL
1xCR123A(3V)
2. Take o the cover.
3. Remove the paper strip protecting
the battery.
4. Proper powering up will be con-
rmed with a short beep.
5. Add the device (as described in "Add-
ing/removing the device") if you
want to use it in the Z-Wave network.