FIBARO FGCD-001 - 6: Visual Indications & Acoustic Signals

8
VISUAL INDICATIONS & ACOUSTIC SIGNALS
Indications and signals:
The CO Sensor is equipped with a LED diode and a buzzer, signalling
menu position and status of the device.
What
you hear
What you see What it means What to do
4 x BEEP
every 5s
4 x RED BLINK
every 5s
Detected pres-
ence of carbon
monoxide which
can kill you!
1. Open the windows
2. Move to fresh air!
3. Contact emergency
services
1 x BEEP
1 x YELLOW BLINK
every 30s
Low battery level Replace the battery
1 x BEEP
every 30s
–
Sensor error
(does not detect
carbon monoxide)
Reset the device,
replace if no eect
2 x BEEP
2 x CYAN BLINK
every 30s
End of lifespan
Reset the device,
replace if no eect
3 x BEEP
every 30s
1 x BLUE BLINK
every 30s
Heat alarm Be cautious of re
1 x BEEP 1 x WHITE BLINK Tamper alarm Check the housing
–
1 x GREEN BLINK
after button press
Device powered –
1 x BEEP
1 x GREEN BLINK
after powering
Added to Z-Wave –
1 x BEEP
1 x RED BLINK
after powering
Not added to
Z-Wave
–
1 x BEEP
1 x MAGENTA BLINK
every 10min
Out of range
Check the Z-Wave
range
– CYAN BLINKING Firmware update Wait for completion
Device status indications:
#6: Visual indications & acoustic
signals
NOTE
Replace the device be-
fore date on the front
or if sensor error is de-
tected.
i