10
INSTALLATION - MOUNTING THE INSTALLATION BOX
Mounting the installation box
Before installation pay attention to:
• Installation box must be mounted using the materials which will
not cause the tension that could deform the shape of a box after
the installation (e.g. by expanding).
• Mounting in the drywall requires using screws with hooks (not
included).
• Mounting in the insulation-lled wall (e.g. drywall with mineral
wool) requires to keep at least 10cm distance from the insulation
to prevent the device from overheating.
To install the box:
1) Prepare hole for 65mm x 75mm (diameter x depth) installation box.
2) Route cables to the back of the hole (see “Choosing and routing wires” on page 8).
3) Drag the cables through the rubber sealing on the back of the box, taking care to keep the tightness.
4) Mount the box in the hole and align it so the TOP arrow points up.
5) Make sure the box is ush with the wall and rmly attached.
It is recommended to use the plasterboard adhesive (type T) to securely install the box.
To Next Page