12 INSTALLATION - CONNECTING WIRES
Connecting wires
To connect the wires:
1) Make sure that no wires are powered.
2) Remove the outer insulation to expose about 5 cm of the insulated inner wires, taking care not to damage them.
3) Separate and straighten the inner wires if twisted.
4) Cut the inner wires to 4 cm in length.
5) Remove the insulation from the inner wires to leave about 5 mm of exposed metal core on each wire.
6) Put the wires inside the terminals using long-nose pliers or tweezers according to diagrams below.
7) Make sure all wires are rmly attached.
Should you need to remove a wire from the connector we recommend to use a dedicated tool - WAGO 2059-189 (not included,
shown below) to minimize the risk of connectors damage.
To Next Page
Loading...