OWNERS MANUAL 15
SERVICE AND MAINTENANCE
F NOTE! The warranty expires and Fimet Oy declines all responsibility if somebody else but
Fimet Oy's authorised service course passed qualified serviceman maintain or repair
this device
THE BACKREST MOTOR AND ITS MECHANICS
To gain access to the backrest motor:
o Remove the armrests and the locking rings that holds the upholstery in place
o Lift the upholstery carefully off the armrest holders and slide it forward of the chair
o Remove the two screws that holds the metal cover in place, and remove it
o The motor and the mechanics of the backrest as well as the mechanics of the control buttons are
now easily accessible
THE MOTOR FOR THE LIFT MOVEMENT
The motor for the lifting mechanism is accessible from the front of the chair.
o Remove the four screws that holds the cover on place.
o If the chair is being serviced for the first time the plastic cover needs to be cut open. Use a sharp
knife and cut both sides along the grooves from bottom to top.
o Fold the plastic cover carefully upwards. The motor is now accessible for service.
PRINTED CIRCUIT BOARD AND SAFETY SWITCH
The printed circuit board and the safety switch are located on the right hand side of the chair next to
the lift mechanism. To gain access, remove the plastic cover by releasing the front corner that snaps
over the metal guide, and then cranking it off carefully. Slip display panel through back cover hole at
the same time. The plastic cover and the bellows are inter connected by means of mechanical
retention and are easily separated. When the cover is removed from the chair the circuit board is
easily accessible for service.
To Next Page
Loading...
