OWNERS MANUAL 6
PRODUCT DESCRIPTION
CONSTRUCTION
The chassis and foundation of the F1 chair are made of a sturdy steel construction. The geometry of
the up- and down mechanism has an ingenious compact design that offers the chair outstanding
flexibility. From its lowest point 35 cm ( 14 inches) the chair moves almost linearly to 91 cm ( 36
inches). All bearing are pre-lubricated and will last almost indefinitely without maintenance. All
visible parts are made of composite materials by using the RIM technique ( Reaction Injection
Molding). The seat, backrest and other force absorbing parts are reinforced.
MOTORS AND ELECTRONICS
The two motors and the electric circuitry of the F1 chair are of low voltage type that reduces the risk
of electrical shock and hazard to a minimum. Steel and composite materials in combination are
used in the gears of the drive mechanism. A configuration that gives the chair a smooth and quiet
ride and a long lifetime of the mechanism. The electronics, including the microprocessors for the
programming functions are concentrated on one circuit board that are conveniently located on the
right hand side of chair. All major components of the F1 chair are easily accessible for fast and
convenient service and maintenance.
All functions of the F1 chair are controlled by means of a cordless foot control that meet the
individual needs of convenience.
Backrest
motor
Control panel
Lift motor
Safety switch
Foot control
Safety switch:
All movement will
stop when the rear
is lift upwards
Recharge connector
Batteries
To Next Page
Loading...
