OWNERS MANUAL 22
6. Put the short circuit piece to place 1-1. Keep the
PROG
-button pushed down.
7. With a screwdriver, make a short circuitry between 2-2, 3-3, 4-4, 5-5.
8. If no ”Beep”-signal, put the short circuit piece to 2-2, and make a short circuitry with a
screwdriver to 3-3, 4-4, 5-5 etc.
PACKAGE POSITION
In order to place the chair in its package, the chair can be driven below its lowest position. Press
USER
-switch (from back panel of the chair) and at the same time press ”chair down” switch at the
foot control.
F NOTE! Chair’s backrest must be at the package position also.
Don’t drive the chair at it’s mechanical limit.
0-POSITION
Since 12.12.1990 there is 0-position or exit position firmly programmed at the factory. This position
is recalled by pressing
PROG
-button from the foot control and activating “backrest-up” -function.
0-position:
PROG
+ backrest up.
CHANGING THE FACTORY PROGRAMMED 0-POSITION
Drive the chair to the desired 0-position (exit position).
Push first
PROG
(from back panel of the chair) and then
USER
so that both remain pushed down and
turn foot control lever rightwards.
SPITTOON PROGRAM
This program works when foot controls middle button (
PROG
-button) is pressed and within three
seconds the left corner button. Pushing left button again brings the chair in it’s original position.
The spittoon position is programmable like any other position.
To Next Page
Loading...