OWNERS MANUAL 7
THE POWER SUPPLY AND MAINS SWITCH
The transformer, the rectifier, the mains switch and the fuses are all housed in a separate power
supply box, apart from the chair for improved safety. Always turn off the mains switch when the
chair is not in use.
F NOTE! When switching on the mains, wait approx. 30 seconds before operating the chair.
The built-in microprocessor is checking that all functions and controls are in order.
(Self diagnostic)
FUSES
The fuses (T 2 A) are housed in the power supply box and are easily accessible. If the power supply
is located in the Floor Box (in firm installation), there is only one fuse, otherways always 2 pcs.
F NOTE! There is a overheating protection switch built-in to the power supply box. In case
where the transformer overheats the overheat protection switch will cut the circuitry
to the chair immediately. When the transformer cools down the safety switch will
automatically go back to its on position. When overheat protection is functioning the
display of the chair indicates H (Hot).
Fuses
Pilot light
Power switch
Connections
Power cord
To Next Page
Loading...
