FINE mechatronics FS-8000 - Auto and Hold Functions

---------------------------------------------------------------------------------
FINE MECHATRONICS FS8000
35
SET AUTO FUNCTION

Auto S/T,G/T in case of HOLD MODE
1 Auto HOLD Function
(
In case F25-00
,
01 it is unavailable
)
2 Auto HOLD Function & Em
p
t
y
HOLD Auto Remove
3 Auto S/T
,
G/T on a stead
y
Lam
p
4 Auto S/T,G/T when a steady weight was in Empty area.
F24-
Additional Reference
0 : The function to totalize when setting the HOLD on auto display
[ It can use it in totalizing and fixing it at the present weight
According to USER.
1 : The function to operate HOLD command and display automatically
To satify F25 without separate HOLD command.
[Whe USER use always HOLD INPUT,This function will be effective.
2 : The same as the above,when it was EMPTY range,
The HOLD command removes and turn out.
[The same as the above function, But
The HOLD remove automaticallly).
3 : It auto-totalize displaying a steady while weighing the weight.
[Available to record the weight and to print it.
4 : After displaying the last steady Lamp while weighing it,
When the Empty range will be after removing the products,
Then the last steady Lam`s weight will be totalized.
[The function to totalize it without printer KEY.)
SET HOLD FUNCTION

Holding the present weight as setting HOLD KEY.
1 Holding a balanced weight for a steady judment delay time
2 When a stead
y
lam
p
was dis
p
la
y
ed
3 When maxium wei
g
ht was dis
p
la
y
ed
(
1 time
)
4
Holding a weight when Maxium weight was displayed An
d
when Maxium weight was renew.
F25-
NOMINATION CODE NUMBER

FIXING
1 1 Increase after weighing 1time
2
1 Decrease after weighing 1time
( "0" is No Decrease)
F26-