FINE mechatronics FS-8000 - 5-2. Basic Functions for Devices; Basic Functions for Devices

---------------------------------------------------------------------------------
FINE MECHATRONICS FS8000
32
5-2 . BASIC FUNCTION FOR DEVICES
SELECTING A KEY LOCK.

Available to use all keys
1
Unavailable to use
G/T,S/T,HOLD,AUTO,PRINT,GROSS KEYS
F10-
2
Unavailable to use ALL KEYS except of
ZERO POINT KEY.
This function was designed to prevent from mis-operating by general user.
ZERO & TARE KEY OPERATING MODE

Zero & Tare KEY will be operated
when a weight was steady.
F11-
1
Zero & Tare KEY will be operated
though a weight was not steady.
TARE WEIGHT INPUT MODE
0 Setting TARE Value after inputting SET/CAL

Setting TARE Value with inputting only by TARE KEY
In the situation of putting a weight,tare
On a weighing plate.
2
Auto Tare Setting if a weight was steady on EMPTY
weight area. Under tare set-up situation,
If Display Weight was steady under Empty Area,
It will be AUTO TARE RE-SETTING.
( It is comfortable in case that TARE weight remove automatically
before working and weighes it after working)
F12-
3
If Gross Weight was steady under Empty area,
It will be AUTO TARE REMOVING.
( It is comfortable in case that the filling works after loadiing TARE on
the weighing part.
* In case selecting NO 2,3,The TRAE Key will be worked to NO 1