8
8. Inspect the engine air cleaner (refer to the engine operator’s manual), the radiator chaff
screen, and the blower air cleaner for dust and dirt. If necessary, clean or replace the air
filter.
9. Check hopper and transition for foreign objects that could injure workers or damage equip-
ment.
10. Check the fluid level in the hydraulic tank. Proper level is when the sight gauge is com-
pletely full with unit sitting on level ground. See Hydraulics, pages 9 through 11, for oil
specifications.
11. Install the discharge hose. Use the clamps provided with the machine.
CAUTION
Do not use radiator type clamps. These clamps may not hold under machine operating
pressure. Failure to comply could result in minor personal injury, product damage, or
property damage.
STARTING PROCEDURE:
CAUTION
See safety section of the manual (pages 1 through 5) before operating the machine. Failure
to comply could result in minor personal injury, product damage, or property damage.
1. Turn key counterclockwise and hold it until the glow plug indicator light goes out.
2. Turn key until starter engages and the engine fires.
NOTE: This engine has a safety system that will shut the engine off if the
engine oil pressure drops below 7 psi or if the water temperature
reaches 230°F (110°C).
3. Check that the ON/FUSE and DOOR SWITCH lights are illuminated. If not, check the
10-AMP fuse in the control box (see Figure 2). Verify that the doors are closed at the rotary
air valve.
4. Initialize the Radio Remote Transmitter by turning on the transmitter.
5. Allow the engine to warm up for 3 to 5 minutes.
6. Prior to mulch application, move the throttle position to wide open, and allow the governor
to control the engine speed. Governed engine speed on the FINN Bark Blower should be
2,700 to 2,800 RPM under a load.
CREW MEMBERS AND THEIR DUTIES:
1. The Operator controls the placement of the mulch by moving and aiming the discharge
hose.
2. The Loader(s) feed material to the machine by using a skid steer or loader tractor, dumping
it directly into the hopper, or by shoveling from the tow vehicle to the feed floor.
To Next Page
Loading...
