FIOCCHETTI ECT-F TOUCH - Page 47

47
OPEN DOOR ALARM
or
OPEN DOOR ALARM
COMPARTMENT A
or
OPEN DOOR ALARM
COMPARTMENT B
 Check delay time for the
alarms. If necessary, change
them, Par 5.2.4
 The door has been left open for
longer than the alarm delay set
(45 -60 seconds)
 Close the door
 The door is not properly closed
 If the problem occurs again,
contact technical service
LOW
TEMPERATURE
or
PRODUCT LOW
TEMPERATURE
 Check the set limits with
reference to the working
setpoint. See Par. 5.2.4
 Too narrow high/low alarm limits
 The refrigerator operates and
is controlled by the on / off of
the last cycles of the
compressor, but you need to
contact Technical Service
 Compressor relay fault
 Unbalanced probes
LOW MAINS
VOLTAGE
 Tap on icon in order to
view alarm list and to mute it
(par.5.2.16)
 Turn the refrigerator off from
the display, -STAND BY-
Par.5.2.8. Turn it on after a
few seconds.
 If the problem occurs again,
do check the voltage by a
qualified electrician.
 Contact sales department for
a voltage stabilizer.
 220V or 115V mains is not stable
and registers spikes lower than
the minimum accepted value.
LOW EVAPORATION
TEMPERATURE
 Turn the refrigerator off from
the display, -STAND BY-
Par.5.2.8. After a while turn it
on and the visual and
acoustic alarm is off.
Tap the off alarm/fault icon so
to permanently delete the
signal (par.5.2.16).
 If the problem occurs again,
contact technical service
 Evaporator fan is stuck
 Electronic board relay fault
 Ice formed on the evaporator
 Faulty defrost heater
 Unbalanced evaporator fan
 Electrical or electronic faults