FIOCCHETTI ECT-F TOUCH - Page 48

48
TIME DEFROST
 Tap on icon in order to
view alarm list and to mute it
(par.5.2.16)
 Turn the refrigerator off from
the display, -STAND BY-
Par.5.2.8 and turn it back on
after a few seconds.
 If the problem occurs again
after the following defrost
cycle, contact technical
service.
 Too many products have been
filled in the chamber.
 Too humid products
 Freezer cabinets: Ambient
temperature < +10° C
or
 Too high ambient temperature
 Faulty defrost heater or solenoid
valve
 Electrical or electronic faults
HIGH CONDENSING
TEMPERATURE
 Clean condenser, Par. 8.3
 Cool down the ambient.
 Turn the refrigerator off from
the display, -STAND BY-
Par.5.2.8. After a while turn it
on and the visual and
acoustic alarm is off.
Tap the off alarm/fault icon so
to permanently delete the
signal (par.5.2.16).
 Condenser clogged with dirt and
dust
 Too high ambient temperature
 Faulty condenser fan motor
 Faulty electronic board relays
 If the problem occurs again,
contact technical service
COMPRESSO WORK
 Clean condenser, Par. 8.3
 Cool down the ambient.
 Turn the refrigerator off from
the display, -STAND BY-
Par.5.2.8. After a while turn it
on and the visual and
acoustic alarm is off.
Tap the off alarm/fault icon so
to permanently delete the
signal (par.5.2.16).
 If the problem occurs again,
contact technical service
 Condenser clogged with dirt and
dust
 Hot ambient temperature
 Continuous working of
compressor for 24hours
 Leakage in cooling equipment.
 Wrong use of equipment, i.e. too
many door openings