FIOCCHETTI ECT-F TOUCH - Page 51

51
PROBE FAILURE
S2 - S3
 In case of S2 or S3 robe
failure, device operation does
not take place regularly.
 Turn the refrigerator off from
the display, -STAND BY-
Par.5.2.8. After a while turn it
on and the visual and
acoustic alarm is off.
Tap the off alarm/fault icon so
to permanently delete the
signal (par.5.2.16).
 Always contact technical
service for the probe
replacement, especially for
S2 probe.
 Disconnected or faulty probe
 S2 Evaporator probe failure
 S3 Condenser probe failure
--%
 Contact technical service for
probe replacement
 Humidity viewer probe
disconnected or faulty
PROBE S1m DMLP
FAILURE
PROBE S2m DMLP
FAILURE
 Device still works properly,
but it does no DMLP S1m
probe recording.
 Turn the refrigerator off from
the diplay, -STAND BY-
Par.5.2.8. After a while turn it
on and the visual and
acoustic alarm is off.
Tap the off alarm/fault icon so
to permanently delete the
signal (par.5.2.16).
 Contact service for probe
replacement
 Disconnected or faulty probe
 S1m DMLP probe failure
 S2m DMLP probe failure (B
compartment or product
simulator)
UNBALANCED
PROBES ALARM
(with DMLP digital
monitor)
 Turn the refrigerator off from
the display, -STAND BY-
Par.5.2.8. After a while turn it
on and the visual and
acoustic alarm is off.
Tap the off alarm/fault icon so
to permanently delete the
signal (par.5.2.16).
 If the problem occurs again,
contact technical service
 Different readings between S1
probe and S1m probe (DMLP
digital monitor)